2/1/2024 0 Comments Freefilesync 7.7![]() O Confirm HMC #1 connects successfully to managed server(s) O Reconnect the ethernet cable from HMC #1 to the managed server(s) O Physically disconnect the ethernet cable from HMC #2 to the managed server(s) O Upgrade HMC #1 to V7.7.7 and install recommended fixes (start with step 8 below since 1-7 were already performed above) O Physically disconnect the ethernet cable from HMC #1 to the managed server(s) O On each HMC, perform a Save Profile Data for each managed system to save an additional copy of partition/profile configurations - complete steps 1-7 of the section below titled Save Profile Data, Save Upgrade Data and Upgrade HMC to 7.7.7. To avoid possible corruption of the partition data on the server, the following is recommended in a redundant HMC environment: If the redundant HMCs are at 7.7.5 or earlier: HMCs at V7R7.5 or lower will not be able to understand the server's partition data properly. Once the server is connected to a V7R7.6 or V7R7.7 HMC, the partition configuration on the server will be migrated to the latest version. When two HMCs manage the same Server, both HMCs must be at the same version. ![]() Note: HMC 7.7.7 does not support dual/redundant management with IBM Systems Director Management Console (SDMC). Find Model Type and Serial number in the HMC Code Level section of the right-hand panel.įrom a restricted shell command line, type the following command and press Enter: lshmc -v *TM is the machine type/model, and *SE is the serial number.Ĭritical special instructions when using redundant Management Consoles On the HMC GUI interface, select Updates in the left-hand navigation panel. To resolve the problem, contact IBM Hardware at 1-80 (800-IBM-SERV), Option 1 for hardware, and request a BIOS flash to correct the MTMS: If they do not match, do not attempt the upgrade. Use one of the methods below to verify that the Machine Type/Model and Serial Number (MTMS) matches the information on the tag on the front of the physical HMC. Servers below the supported level should be updated after the HMC upgrade is complete.Ĭonfirm machine type/model and serial number are correct O If an HMC is used to manage any POWER7 processor based server, the HMC must be a model CR3 or later model rack-mount HMC or C05 or later deskside HMC.įor a complete list of supported combinations of HMC V7 code levels and server firmware levels. Not supported and cannot be installed on HMC models C03, C04 or CR2. ![]() This document provides instructions to upgrade the HMC from Version 7.3.1 or later to Version 7.7.7. Upgrading the HMC from Version 7.3.x or Version 7.7.x to Version 7.7.7 Follow the instructions on the window to back up the data.You can back up to media on the local system, back up to a mounted remote system, or send backup data to a remote site. In the Navigation area, click HMC Management. 另外,用户需要安装linkxlC (ORACLE EBS产品),需要下载vacpp runtime Environmen. HMC->HMC Management –>Save Upgrade Data –>Disk. 在HMC上->System management->依次选中每个服务器->Configuration->Manage Partition Data –>Backup –>Profile Data Backup (填入文件名) 包括Save Profile Data, Save Upgrade Data两部分。
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |